Previous        Up        Next

LCR Delay






The LCR Delay creates echo effects by mixing the original signal with three delayed signals (left, center and right).


Delay Unit - Sets the delay to be in milliseconds or steps.  Available in the multitrack editor only.


Step Length - Sets the delay steps to 1/16 or 1/8T of a note.  Eighth triplet is the equivalent of 1/12 of a note.  Available in the multitrack editor only.


Mono/Stereo - Sets the delay to operate in mono (mixes the left and right input signals) or stereo.


Delay - The amount of time the signal is delayed.


Level - The level of the delayed signal.


Feedback - The amount of the output signal that is fed back into the input.  Negative numbers invert the feedback signal.


Damp Low Freqs. - The amount that the feedback signal is high pass filtered.


Damp High Freqs. - The amount that the feedback signal is low pass filtered.


Stereo Spread - The width of the stereo image.  Negative numbers swap the left and right outputs.


Dry/Wet - The balance between the dry and wet signals.